Camlok Groundwork & Construction Lifting Clamps

Camlok CP Pile Pitching Clamp

UK manufactured plate clamps designed specifically for lifting steel piles in to position. Supplied as standard with a 15 metre remote release rope. Capacity options from 2 to 5 tonnes.

Model: Camlok CP / PPC-361

The Camlok CP is designed specifically for pitching sheet steel piling, it is NOT designed to extract a driven pile. A rope is fitted for easy release from the ground.

Camlok PH Pipe Hooks

Pipe section hooks sold and designed to be used in pairs for horizontally lifting and transporting pipes or tubes from each end. Supplied with shackles, but chains are not included. Capacity options from 2 to 10 tonnes.

Model: Camlok PH / PH-362

Camlok PH Series Pipe Hooks are used in pairs to handle pipe / tubes etc.  Available with 2 legged chain slings and / or polyurethane coated Type A, 60 to 90 degrees Type B, 90 to 120 degrees. They are manufactured from special high tensile steel

SWL (safe working load) options available: 2 tonnes, 4 tonnes, 6 tonnes, 8 tonnes and 10 tonnes.

Camlok BTG Concrete Pipe Clamps

Set of 3 clamps designed specifically for the lifting of concrete pipe sections. Capacity options are 1.5 or 3 tonne.

Model: Camlok BTG / CPC-366

The Camlok BTG clamp is designed to vertically lift and position concrete manhole pipes. The clamps can be adjusted to different wall thicknesses using the adjusting pin and the holes inside the clamping arms. The BTG concrete pipe clamp is designed to vertically lift and position concrete manhole pipes. The clamps can be adjusted to different wall thicknesses using the adjusting pin and the holes inside the clamping arm. The clamps can be used in pairs with 2 leg chain slings or with 3 clamps and a 3 leg chain sling for larger diameters, providing they are attached in a way that the load is evenly distributed. Use of the BTG clamp enables the manhole trench size to be minimized and facilitates accurate pipe positioning.

Camlok PP Pile Pulling Clamp

UK manufactured clamps specifically designed to pull and remove driven piles or trench shields. Capacity options are 3 or 8 tonnes.

Model: Camlok PP / PPC-360

Camlok TBG & TST Scissor Block Grabs

Camlok scissor grab with rubber pads or teeth and with manual latching mechanism, for lifting blocks. Range from 200kg to 1000kg

Model: Camlok TBG / SBG-373

Camlok TSA Lightweight Block Grab

Adjustable single arm block grab for lifting stone or concrete blocks and kerb stones etc. 250/500 kg. UK manufactured.

Model: Camlok TSA / SABG-370

This grab is fitted with a lock to secure the spring-loaded arm. The large handle makes it easy to carry by hand. It can be designed for any working load limit and with jaw width capacity to suit customer requirements. It is fitted with plastic pads for efficient grip and to prevent damage to the load. Designed for picking up kerbstones, blocks etc.

Camlok TRU Round Stock Grabs

Round section lifting clamps for tubes, pipes, rolls or similar up to 600mm dia. Capacity options from 100kg up to 3 tonnes. UK manufactured.

Model: Camlok TRU / RSG-368