LIFTINGSAFETY

Tractel TOPAL LT Lever for separating plates

Telescopic 'knock in' bar with wedge at the end for separating plates in a bundle

Model: 

Tractel TOPAL LT / TTL-3303


Telescopic bar with wedge at the end for separating plates in a bundle. The lever is fitted with a sliding shaft allowing its end between the plates.

  • Lever for separating plates
  • Do not use on fragile plates
  • Manufacture without load bearing welds
  • Hot epoxy coating
  • Safety factor: 3 (EN 13155.2003 norm)
  • Overall Length: 830-1290mm
  • Tip width: 40mm
  • 'Wedge' length: 267mm
  • Weight: 7kg

Instructions

  1. Allow a wedge near the operating place. Insert the lever end between 2 plates.
  2. Strike thanks to the sliding shaft so that the end penetrates between the plates.
  3. By pulling the lever up, the top plate will lock itself in one of the lever’s throats.
  4. The wedge will then be slid between the 2 plates.

 

LT T 6022 GB rev 1.pdf

Technical Data Sheet

(approx. 0.2Mb)

Telescopic bar with wedge at the end for separating plates in a bundle. The lever is fitted with a sliding shaft allowing its end between the plates.

  • Lever for separating plates
  • Do not use on fragile plates
  • Manufacture without load bearing welds
  • Hot epoxy coating
  • Safety factor: 3 (EN 13155.2003 norm)
  • Overall Length: 830-1290mm
  • Tip width: 40mm
  • 'Wedge' length: 267mm
  • Weight: 7kg

Instructions

  1. Allow a wedge near the operating place. Insert the lever end between 2 plates.
  2. Strike thanks to the sliding shaft so that the end penetrates between the plates.
  3. By pulling the lever up, the top plate will lock itself in one of the lever’s throats.
  4. The wedge will then be slid between the 2 plates.

 

LT T 6022 GB rev 1.pdf

Technical Data Sheet

(approx. 0.2Mb)

Contact Us About This Product

LiftingSafety uses cookies to improve your user experience,
To accept this, please click the 'accept' button below.

Top