Camlok TCS Coil Lifting and Turning Hook

The TCS coil turning hooks are specifically designed to pick up coils of steel or reels of banding material which are lying flat. Once the turning hook is positioned and the crane hook is raised, the coil automatically transfers from the horizontal position to the vertical position. This allows for easy transportation and also allows for loading onto machines or racking.

TCS Features

• The TCS is a universal C-hook.
• The tipping device helps prevent the accidental slipping of the load.
• Designed for lifting & turning coils, rolls and rings from the horizontal position.
• The tipping feature allows the coil to be lifted or lowered, whether the coil is flat or upright.
• Designed and manufactured in the UK.

Applications

Designed for lifting and handling coils, rolls and rings, etc, in the horizontal position. Never try to lift a load longer than the length specified. The maximum working load limit must not be exceeded.

Restrictions

Never try to lift a load longer than the length specified. The maximum working load limit must not be exceeded.

Options

• Custom-designed and manufactured C-hooks to suit other working loads or dimensions are available on request.
• The tine length and usable height most commonly requested can be found in the table below.
• Twin Arm C-hook - Available to suit a variety of loads

Step 1:
Place the hook into the coil centre as shown below with the back of the lifting shoe touching the inside of the coil and the lifting sling vertical. Slowly hoist up until the coil rises from the ground.

Step 2:
As the coil is slowly lifted, then traverse the crane backwards so that the coil pivots on the lower rear corner from the horizontal position in to the new vertical position.

Step 3: Continue hoisting and traversing the crane until the coil is vertical. Take special care when the pivot point is below the cog of the coil as the coil will topple back into the hook. If thin coils are lifted then place the coil down on its edge and move the coil to the rear of the hook for transporting

Dimensions & Specifications

Model	Min Int Dia. (ø1) (mm)	A (min-max) (mm)	B (mm)	C (mm)	D (mm)	E (mm)	F (mm)	G (mm)	H (mm)	J (mm)
TCS 0.5 / 120	220	50 - 120	470	60	330	110	60	20	20	45
TCS 0.5 / 200	300	100 - 200	470	60	330	110	60	20	20	50
TCS 1.0 / 200	300	100 - 200	600	60	460	110	80	25	20	65
TCS 1.0 / 300	400	200 - 300	600	60	460	110	80	25	20	70
TCS 2.0 / 200	300	100 - 200	600	75	420	135	90	30	30	85
TCS 2.0 / 300	400	200 - 300	600	75	420	135	90	30	30	95
TCS 3.0 / 200	300	100 - 200	820	90	610	160	100	35	40	100
TCS 3.0 / 300	400	200 - 300	820	90	610	160	100	35	40	110