Specially designed pins for the lifting of man-hole pipes. 25mm, 32mm, 35mm or 38mm Diameters available.

Pin Anchor Ring Clutch lifting device manufactured from several cast components, Capacity Range from 1 tonne to 45 tonne.

Pin Anchor Ring Clutch lifting device manufactured from several cast components, Capacity Range from 4 tonne to 10 tonne.

Pin Anchor Ring Clutch lifting device manufactured from several cast components, Capacity Range from 1 tonne to 20 tonne.

Spread Anchor Ring Clutch all cast lifting device, Capacity Range from 0.70 tonne to 20 tonne.

Camlok Pipe Hooks. Camlok PH Series Pipe Hooks are used in pairs to handle pipe / tubes etc.  Available with 2 legged chain slings and / or polyurethane coated Type A, 60 to 90 degrees Type B, 90 to 120 degrees. They are manufactured from special high tensile steel

SWL (safe working load) options available: 2 tonnes, 4 tonnes, 6 tonnes, 8 tonnes and 10 tonnes.

Vertical Lifting Clamp for Concrete, Pipe Sections and Wells.

 

 

Camlok Concrete Pipe Section Lifting Clamps.

The Camlok BTG clamp is designed to vertically lift and position concrete manhole pipes. The clamps can be adjusted to different wall thicknesses using the adjusting pin and the holes inside the clamping arms. The BTG concrete pipe clamp is designed to vertically lift and position concrete manhole pipes. The clamps can be adjusted to different wall thicknesses using the adjusting pin and the holes inside the clamping arm. The clamps can be used in pairs with 2 leg chain slings or with 3 clamps and a 3 leg chain sling for larger diameters, providing they are attached in a way that the load is evenly distributed. Use of the BTG clamp enables the manhole trench size to be minimized and facilitates accurate pipe positioning.

Beam for lifting and laying conical pipe sections, Topal SCX, Topal CX.

The CX ensures contact at two points of loading. The SCX is more robust for intensive use and ensures 3 point loading. These accessories are fitted with polyurethane coated pads which enable the handling of cone shaped manholes without marking. Delivery includes a chain sling (CX1 model).

Camlok Round Stock Grabs, for Lifting Tubes, Pipes, Rolls or Similar Stock up to 600mm Dia.

Camlok Scissor Block Grab with Rubber Pads or Teeth with Manual Latching Mechanism.

Camlok Single Arm Block Grab for stone, concrete blocks and kerb stones etc.

This grab is fitted with a lock to secure the spring-loaded arm. The large handle makes it easy to carry by hand. It can be designed for any working load limit and with jaw width capacity to suit customer requirements. It is fitted with plastic pads for efficient grip and to prevent damage to the load. Designed for picking up kerbstones, blocks etc.