Ridgegear Restraint Lanyards, Fall Prevention & Avoidance

Ridgegear RGL5 Fall Restraint Lanyard is to act as a leash for an operative working at height to prevent possibility of risk of a fall. It is important to understand the principles of "fall restraint" as the RGL5 can only be used for fall restraint, as there is no shock absorption built into the system. If there is any possibility of an operative falling, a fall arrest product must be used. Available in any length of upto 2m.

Ridgegear RGL12 Fall Restraint Lanyard is an adjustable restraint lanyard, and various lengths are available to act as a leash for an operative working at height. The adjust-ability of the product ensures that the correct length can be selected for the task in hand. It is important to understand the principles of 'fall restraint' as the RGL12 can only be used for fall restraint, as there is no shock absorption built into the system. If there is any possibility of an operative stepping/falling over an exposed edge, or falling through a fragile surface, a fall arrest product should be used.

Ridgegear Adjustable Twin leg Restraint Fall Arrest Lanyard length can be adjusted to suit the application. The additional benefit of adjust-ability allow for greater flexibility. Can be used for fall restraint, as there is no shock absorption built into the system. If there is any possibility of an operative steeping / falling over an exposed edge, or falling through a fragile surface, a fall arrest product should be used. Supplied in two standard lengths : 0.8 - 1.3mm and 1.2 - and 1.8m.

Ridgegear RGL14 Twin Leg Restraint Fall Arrest Lanyard should be used when the operative is working from a static position, connected to a fixed anchor point. Movement between anchorages can be achieved by means of double clipping. The RGL14 is supplied in two standard lengths 0.9 - 1.3 metre and 1.2 - 1.8 metre. No Hooks Supplied.

The RGP1 is a pole strap / work-positioning device, designed to be clipped to the side Dee's of a harness or work-positioning belt. The adjuster is easy to use "one handed" either under tension or not. The 16mm hard lay rope is additionally protected by a cordura sleeve in the work area, to offer some protection against abrasion and extend the life of the product. The 2m length of the RGP1 allows the user enough freedom of movement, without being exposed to a fall.

The RGP4 is a multi purpose work positioning device, designed to be clipped to the side D's of a harness, work positioning belt or be used independently. Can be supplied in a variety of lengths.

The RGl4 is supplied in 450mm length and is usually used as an extension strap fitted to the D ring of a full body harness. Made with 25mm 40kN webbing in the manufacture of this product which provides greater strength, wear and sheer resistance compared to other webbing. Has a sewn loop eye on free end.