Crosby S505 Nat. Steel Swaging Sleeves - Range Available 6mm to 114mm

Product Images - (Mouse-over). Note: Some images may be for display purposes only and not necessarily included as standard.

Crosby S505 National Steel Swaging Sleeve

Dimensional Drawing

Crosby National Steel Swaging Sleeves.

Standard Steel Sleeve terminations have efficiency ratings as follows based on the catalog strength of wire rope. The QUIC-PASS swaging system allows "Flemish style" wire rope terminations to be swaged in only two passes. Resulting in a 50-75% reduction in the number of passes required with conventional swaging systems. This is accomplished while maintaining currently published efficiency ratings and utilizing National Swage S-505 Standard "Cold Tuff" Steel Sleeves.

• Designed for low temperature toughness.
• Resists cracking when swaged (equals or exceeds stainless steel sleeves).
• Special processed low carbon steel.
• "Cold Tuff " for better swageability.
• Can be stamped for identification after swaging without concern for fractures when following these directions.
• Use round corner stamps to a maximum depth of 0.015 in. (1/64). The area for stamping should be on the side of the sleeve in the plane of the sling eye, and no less than 0.250 in. (1/4) from either end of the sleeve.

• Allows the dies to close completely with each pass, resulting in...
• An increase in overall swaging process efficiencies (the job can be performed quicker).
• A reduction in the complexity of swaging (the concern for excess flashing between dies has been eliminated.
• A reduction in raining time needed for operations (more user friendly).
• The finished sleeve has a "Hex" appearance that provides a QUIC-CHECK look to determine if the termination has been swaged and provides a flat surface that allows for ease of I.D. stamping on the finished sleeve.

Metric Dimensions

	S-505 Termination Efficiency
	Size (mm)	Type of Wire Rope *
		IWRC	FC
	6 - 26	96%	93%
	28 - 52	92%	89%
	56 and Larger	90%	87%

Imperial Dimensions

	S-505 Termination Efficiency
	Size (in.)	Type of Wire Rope *
		IWRC	FC
	1/4 - 1	96%	93%
	1-1/8 - 2	92%	89%
	2-1/8 and Larger	90%	87%

** NOTE: S-505 Standard Sleeves are recommended for use with 6 x 19 or 6 x 37, IPS or XIP (EIP), XXIP (EEIP), RRL, FC or WRC wire rope.
Before using any National Swing fitting with any other type lay, construction or grade of wire rope, it is recommended that the termination be destructive tested and documented to prove the adequacy of the assembly to be manufactured.

As advertised in Crosby General Catalogue 2009 Page 40, and previously in Crosby General Catalogue 2006 Page 36.