Camlok Steel Beam Lifting / Suspension Clamps - To Suit UB, RSJ, I Section or H Section

Camlok series of CG general purpose clamps can be used on rolled steel joists, beams, fabrications and RSJ's up to a surface hardness of 300 Brinell. This clamp can lift and turn girders through 90° and has been designed to meet the requirements of the heavy steel industry. It incorporates a positive lock on to one of the uppermost edges, which will allow the beam to be set down with the web or flange vertical. For longer girders, fabrications and welded structures two clamps and a lifting beam may be required.

The TTR Series of Clamps have been designed to lift and transport structural steel beams in the horizontal position i.e. with the flanges in the vertical position. The clamp is designed with the hook ring as near as to the centre of gravity of the beam as possible, thus resulting in a near horizontal lift. Long beams should be lifted using 2 clamps attached to opposite beam flanges. The clamp is fitted with a Camlok spring/cam operated safety lock.

The TTG Girder Clamp is designed to lift and transport structural steel beams in the vertical position i.e with the flanges in the horizontal position. The clamp is fitted with a Camlok spring operated safety lock and is operated by pulling the locking handle upwards. Long beams should be lifted with two clamps attached on opposite beam flanges, the clamps supported from a lifting beam.

The TTG is ideal for lifting and transporting structural steel beams and girders. Long beams can be lifted using 2 clamps attached to opposite beam flanges. The clamp is fitted with a Camlok spring / cam operated safety lock.

 

The TTT Series Clamp is a variant of the TTG clamp but this clamp is designed to be used in pairs supported from a 2 legged chain sling. The bottom toe plate is split thus enabling the clamp to be attached to the end of the structural steel beam. The clamp is fitted with a spring operated safety lock. Particularly used for erecting structural beams on construction sites.

The Camlok series of TTT clamps can be used on girders up to a surface hardness of 300 Brinell. Girders can be lifted vertically from their ends so that steel beams can be transported with the flanges in a horizontal position.

This Fixed/Swivel beam clamp has a Wide Flange Range
Options available: 3000kg=range 100-270 mm, 5000kg=range 75-305 mm

Fitted with swivelling jaws that provide a positive grip on the bottom flange of rolled steel joists. Jaw automatically rotates into the horizontal position ensuring the full width of the jaw is in contact with the flanges.

The clamp can be quickly and easily attached to both beams via the screw mechanism. The SCT twin clamps can be supplied fixed at parallel, at 90º to each other or with a swivel mechanism that allows 360º rotation. Used for supporting vertical loads only. Enables one beam to be suspended beneath another.

This clamp is useful for various flange widths due to large jaw capacity. The clamping jaws hold the load firmly in place. Designed to transport girders, profile steel etc.

Models available: 500, 1500, 3000 kg